1. #1
    Hi all,

    I want to send my KRV 2000 bed, knee and saddle to be reground and turcited. I was told by the various grinder that I could palletise the parts and get them shipped.

    Has anybody done this for a knee mill with a 50" table here? If so any pointers would be greatly appreciated.

    I have a standard 1x1.2m pallet ready to go.
    Stocking more goodies than just Smoothsteppers

  2. #2
    I have successfully shipped (Within Uk) a 6ft x 6ft x 12" deep car lifter by attaching a pallet to it with the wrap they use in builders merchants that looks like cling film.
    In your case I would borrow a strapping machine which you can strap the items securely to a pallet and then wrap with the film using the last wrap around to cover the address label etc.
    You'll probably need to get it weighed as well as many pallet companies charge by weight.
    I have used these people before http://www.pallet2ship.co.uk/
    If you can't fix it with a hammer you've got an electrical problem !

Similar Threads

  1. Holding vice to table advice
    By lateAtNight in forum General Discussion
    Replies: 20
    Last Post: 24-11-2014, 05:39 PM
  2. Vacuum Table Advice
    By Minium in forum Milling Machines, Builds & Conversions
    Replies: 13
    Last Post: 13-11-2012, 08:52 AM
  3. Advice on new table and ball screw.
    By D-man in forum Gantry/Router Machines & Building
    Replies: 9
    Last Post: 26-07-2012, 09:45 PM
  4. Replies: 1
    Last Post: 31-12-2011, 11:34 PM
  5. NEW MEMBER: back in the saddle
    By abos in forum New Member Introductions
    Replies: 0
    Last Post: 24-07-2009, 08:21 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts