Page 2 of 2 FirstFirst 12
  1. #11
    Ahh the sweet smell of success. Simply replacing the cable with shielded cable did the trick. I had to do a little bit of poking about with the pulley speed setting to get the intermediate values to fall into line, but now they all agree within around 20rpms. Thats good enough for me.

    Thanks JAZZ and Clive for all your help.

    BTW Clive there is no daughter board, the BOB has the PWM output directly on the board.

  2. #12
    Ok Well I don't think that I help much but Its good to bounce off people to get to the conclusion. Good luck ..Clive

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Replies: 5
    Last Post: 29-09-2014, 02:42 PM
  2. Spindle Speed Control
    By cncJim in forum Spindles & Drive Motors
    Replies: 15
    Last Post: 18-06-2013, 07:53 PM
  3. eBay: UIM2901-5A Mach3 breakout board with spindle speed control
    By Fivetide in forum Items On eBay UK
    Replies: 0
    Last Post: 05-02-2013, 07:25 PM
  4. Spindle Speed Measurement
    By clockmaker in forum Spindles & Drive Motors
    Replies: 2
    Last Post: 04-12-2010, 11:38 PM
  5. High speed spindle
    By leadinglights in forum Tool & Tooling Technology
    Replies: 0
    Last Post: 27-04-2010, 09:23 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •