Threaded View
-
12-04-2015 #1
Hi everyone.
I bought a home-built, secondhand machine just over 3 years ago. I've self-taught myself(was a complete novice) to use it and it has been working fine but now it's broken down and I could do with some advice as to where to start looking/what the problem may be please.
Machine was running today for about a minute then just stopped. It says E-STOP ACTIVATED. I reset it, pressed 'run program' but nothing happened. I've checked wiring and cleaned all the dust etc out of it about a week ago(had running since then though). The following is some info on my machine:-
It is a fixed gantry CNC machine
Overall dimensions
Wide 800mm, deep 900mm, height 1450mm
Cuts approx 500mm x 400mm
Components are:-
Nema23 keling motors on all axis
Controller gecko G540
Running Mach3 program
Regards,
Al
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Advice needed on Amadeal
By croy in forum General DiscussionReplies: 13Last Post: 21-08-2015, 01:28 PM -
bit of advice needed for first mill
By jmac80 in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 06-04-2014, 10:59 PM -
First steps, advice needed
By Wobblycogs in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 02-11-2012, 02:30 PM -
Advice needed for Z Design
By Hobgoblin in forum Linear & Rotary MotionReplies: 8Last Post: 10-09-2012, 09:18 PM -
SPG X3 CNC Mill, advice needed please
By shaggyhawkings in forum Milling Machines, Builds & ConversionsReplies: 4Last Post: 07-01-2010, 11:00 PM
Bookmarks