Page 2 of 2 FirstFirst 12
  1. #11
    Quote Originally Posted by Clive S View Post
    And the problem was!!!!
    Not 100% sure really but perhaps the parallel cable or the wiring or something else!!! I've tried so much over the past few days, it's hard to tell!!! The most important thing is it's running again, so we can continue cutting orders for our customers.

  2. #12
    Quote Originally Posted by 1albobs View Post
    Not 100% sure really but perhaps the parallel cable or the wiring or something else!!! I've tried so much over the past few days, it's hard to tell!!! The most important thing is it's running again, so we can continue cutting orders for our customers.
    Spoke too soon!!! The following issue is now occurring:-
    Start program and the machine cuts for approx. 30 seconds. It then stops and the E-Stop lights up on Mach3. A page then pops up saying something along the lines of 'automatically toggle switches to on/off position'. I click on that then reset the E-Stop on Mach3 and no motors move but the XYZ counters continue to move but the router stays in a fixed position. Getting very frustrated with this now. :/
    Any ides please fellas??
    Regards,
    Alan

  3. #13
    Quote Originally Posted by 1albobs View Post
    Spoke too soon!!! The following issue is now occurring:-
    Start program and the machine cuts for approx. 30 seconds. It then stops and the E-Stop lights up on Mach3. A page then pops up saying something along the lines of 'automatically toggle switches to on/off position'. I click on that then reset the E-Stop on Mach3 and no motors move but the XYZ counters continue to move but the router stays in a fixed position. Getting very frustrated with this now. :/
    Any ides please fellas??
    Regards,
    Alan
    Gone to put the machine on this morning and got nothing at all now....right back to square one. Will post some pics asap but if anyone is around to offer help/advise then I'd be really grateful.
    Regards,
    Alan

  4. #14
    Sent a reply to your PM.

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Gecko G540 or?
    By JW1977 in forum Gantry/Router Machines & Building
    Replies: 34
    Last Post: 17-09-2017, 05:28 PM
  2. FOR SALE: Gecko G540 Controller & Accessories
    By jeboa in forum Items For Sale
    Replies: 3
    Last Post: 21-09-2013, 09:45 AM
  3. Replies: 4
    Last Post: 08-05-2013, 11:31 AM
  4. Gecko G540 - local source
    By compfranon in forum Motor Drivers & Controllers
    Replies: 26
    Last Post: 10-09-2011, 07:06 PM
  5. Gecko G540
    By Sparks in forum Motor Drivers & Controllers
    Replies: 14
    Last Post: 29-11-2010, 04:52 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •