Hi

I am looking for someone that has or has 'access to' a basic milling machine to do a few small jobs for me.
I used to have someone that undertook the work for me at little cost but I have lost touch with him.
Most jobs involve drilling out M5 Stainless Steel grub/set screws from steel and alloy parts, 4.2mm cutters can be supplied if needed :)
I can normally re tap by hand but you can always feel free to do that yourself.
I am a none profit making radio control hobbyist!

More complex jobs are snapped off screws in very expensive alloy parts! normally flush with the surface.. with the correct set up would be an easy job for me but I don't have access to the right tools!


Thanks in advance for any help any one can give.

Ross