1. #1

    I can successfully profile cut through 120mm deep Kingspan insulation board using just a ground 8mm drill bit. By running the cnc really slowly and also keeping the spindle speed right down to 2000rpm.

    I wanted to use the same process to cut through 120mm blue Floormate Styrofoam BUT it acts completely differently. I need a new approach as the drill is melting the foam and getting gummed up.Wrong speed? spindle going to fast and the drill bit running toohot?-wrong cutter?

    Perhaps the Styrofoam green acts differently to the blue?

    The reason i'm pursuing using the Styrofoam is to use to make masterforms for aluminium casting. I can pour the aluminium directly onto the styrene which is vapourized on contact with the alu. Kingspan hasa higher fire rating and wont dissolve in the same way.

    Has anyone written an extensive list or seen a link to a list of polystyrene and foam plastics and how to router, carve into them andwith which mill ends and feeds and speeds?

    Any help much appreciated
    Last edited by marbles; 21-08-2015 at 10:33 PM.

  2. #2
    Different materials I think, kingspan is polyisocyanurate, PIR foam which machines realy well.

    Styrofoam is polystyrene , guessing need a lot sharper cutter to stop it chewing.

    Frog are the name springs to mind with long cutters for foam

    Last edited by Musht; 23-08-2015 at 11:44 AM.

  3. The Following User Says Thank You to Musht For This Useful Post:

Similar Threads

  1. Polystyrene Cutter
    By kingcreaky in forum Marketplace Discussion
    Replies: 2
    Last Post: 12-05-2014, 07:44 PM
  2. BUILD LOG: New build - fixed gantry mill using extruded profile
    By toolchimp in forum DIY Router Build Logs
    Replies: 3
    Last Post: 09-11-2012, 03:10 PM
  3. Cutting bits nomenclature - help requested
    By DanielF in forum Tool & Tooling Technology
    Replies: 2
    Last Post: 12-05-2012, 03:53 PM
  4. Polystyrene hardening product
    By GASANT in forum Marketplace Discussion
    Replies: 4
    Last Post: 18-04-2012, 01:25 AM
  5. Extruded alu and mounting rails on em
    By CNCBlug in forum Gantry/Router Machines & Building
    Replies: 5
    Last Post: 04-03-2010, 05:50 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts