MCB reccomendation for router

[Leadhead]

Just putting together 6040 size router, 2.2KwInverter, 2.2KwSpindle WC, 3x Nema 23 Steppers, 3 x Stepper Drivers (DM542A) and S350-36 36v 10a PSU. - I have same suitable BOBs but would like to consider an integrated MCB. I recall jazz made some recommendations, but I cannot find the post? Would like to use existing drivers and to stay with Mach3.
If anyone would be able to advise. Your kind assistance appreciated.

[Leadhead]

Looking at some cards and they seem to require clean 5V supply. How do I do that please?

[routercnc]

Do you mean Micro B servo drives? Or do you mean Miniature Circuit Breakers? Or something else?

5V can be obtained from the PC power supply (check one of the spare molex plugs inside the PC with a voltmeter to find the 5V supply). Or you can buy a DIN rail mounted 5V supply which runs off mains - note that this must be used inside an electrical cabinet as it will have exposed terminals.

[Leadhead]

Motion Control Board.

[komatias]

Motion Control Board.

Did you have a short list of boards?

Personally, I would only recommend the Ethernet Smoothstepper or CSMios higher end offerings. (hard to believe that the CSMIO ip-M does not do backlash compensation? Jazz can you confirm this is the case?)

[JAZZCNC]

Did you have a short list of boards?

Personally, I would only recommend the Ethernet Smoothstepper or CSMios higher end offerings. (hard to believe that the CSMIO ip-M does not do backlash compensation? Jazz can you confirm this is the case?)

Honest answer is I don't know because I don't and wouldn't use Backlash comp if it did. To me Backlash comp is a bodge and not very affective. Much better to remove backlash than try let software deal with it.

Thou looking at the spec of the IP-M it says not only the IP-S and IP-A, so I guess not.!! . . . . No big deal to me really. Machine with backlash is a wornout machine to me.!. .