Posting this here to see if there's any interest, as I currently have no use for it.
It's a complete ISO15 spindle, with 8 BT15-ER16 tool holders, and air cylinder for the release.
I'm open to offers.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
This bit of kit you have here is interesting to me, in as much as I would like to undertand how such would be set up. It is not the tool for me mind. I am looking for an ATC that will take a 12.7mm / 1/2" collet then someone to build me a router. That said, I bet this will make someone a nice bit of kit. If you have anymore info I would like to have a read up on it just out of interest.
All the best
I'm guessing it's this one?
If so, what rated speed are the bearings you got in it? I may be interested...
"The spindle cartridges and spindle shaft kits are supplied with NTN P42 25deg sealed angular contact bearings and are available with optional ceramic bearings at an additional cost."
Last edited by Lee Roberts; 31-10-2015 at 06:33 PM..Me
Yes, it's the kickstarter spindle, and I only went for the standard bearings, which are supposed to be rated for 15'000rpm.
If it had been delivered on time, I would of had a use for it, however at the moment it's just an expensive shelf decoration unless I happen to find a cheap donor machine.
Last edited by m_c; 31-10-2015 at 06:48 PM.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
As it stands, it cost me $1200 plus import tax/VAT.
I know I probably won't get anywhere near that, but I'm not going to let it go for nothing!
Feel free to PM me an offer.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
By deisel in forum Items For SaleReplies: 3Last Post: 11-03-2015, 09:48 AM
WANTED: BT 35 Tool HoldersBy Sparky in forum Items WantedReplies: 2Last Post: 08-01-2015, 05:34 PM
By corkcnc in forum Items WantedReplies: 0Last Post: 14-08-2014, 08:43 PM
By m_c in forum Marketplace DiscussionReplies: 12Last Post: 14-09-2013, 01:15 AM
By Kai in forum General DiscussionReplies: 0Last Post: 19-07-2011, 02:22 PM