1. #1
    Hello guys my interests are in engineering in general as I am a machinist by day and model engineer with an interest in clocks by night, I have a manual lathe and milling machine as well as a denford triac with a fanuc control which is used regular and a denford novaturn which I have never used my latest machine is a boxford 165 HMC which I hope to convert to Mach 3, I will definatley have lots of questions some of which I may ask you to explain in a simple way.
    my next challenge is learning Mach as I only use fanuc but 1 step at a Time!!
    chris w.

  2. #2
    Welcome to the forum and good luck Chris.

    The conversion sounds promising, feel free to fire off your questions as/when your ready, we have quite a few Boxford users on here.

    .Me
    .Me

Similar Threads

  1. EXPERIENCE: corkcnc ... a short tale
    By purpose in forum Trading Experience & Feedback
    Replies: 0
    Last Post: 29-12-2013, 04:43 PM
  2. NEW MEMBER: New Member Introduction
    By oldwoodworker in forum New Member Introductions
    Replies: 1
    Last Post: 11-04-2013, 01:56 PM
  3. NEW MEMBER: New member introduction
    By Martin Connelly in forum New Member Introductions
    Replies: 2
    Last Post: 17-12-2012, 03:21 PM
  4. NEW MEMBER: Hello all from the latest new member!
    By Microwhite in forum New Member Introductions
    Replies: 5
    Last Post: 25-04-2012, 02:45 PM
  5. NEW MEMBER: New Member Introduction
    By Ekfer in forum New Member Introductions
    Replies: 1
    Last Post: 22-04-2012, 06:41 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •