1. #1
    alboy's Avatar
    Lives in Roscommon, Ireland. Last Activity: 12 Hours Ago Has been a member for 3-4 years. Has a total post count of 87. Received thanks 8 times, giving thanks to others 3 times. Referred 1 members to the community.
    When looking for cutters there are an awful ot of combinations not just of HSS, Carbide or coated but also a lot of choce in Helix angle, Grain size of material , number of flutes and HRC (hardness) Anyone out there techie enough to give the pros and cons of these latter options. Especially regarding wooden and composite wood materials.


    Last edited by alboy; 29-11-2015 at 04:17 PM.

Similar Threads

  1. EXPERIENCE: Huge Thanks to Jazz
    By alboy in forum Trading Experience & Feedback
    Replies: 0
    Last Post: 22-09-2015, 09:24 AM
  2. Jazz you out there ?
    By John S in forum General Discussion
    Replies: 4
    Last Post: 12-10-2013, 05:24 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts