Hi, I have got the machine axes connected tonight to the csmio and powered up to test all was good apart from y axis no movement so x,z and a good (x needs reversing changing the setting to low made no difference) that is now a small problem as I tried the CS labs mpg unit and its lumpy in the movements so I read on forum that the mpg sets up its own settings when installed and you do not need to enable MPG#1 but when I installed the plugin I set it to enable, so
i put it back to "not enabled" and all my settings for the machine have gone even the default IP address!!
i set channels for motors and try to save but get " wrong value in axis encoder PPR value" message I have guessed at a few numbers but no luck have I completely wiped this motion controller of life??
or is there a download that can restore basic info as the info I had wasn't far from default?
thanks for any help,