. .
  1. #1
    Hi guys,
    The spanner I was sent has slowly wore away and now it just spins round the shaft rather than grip into the indent.
    I'm not 100% sure where to purchase another one from.. when I search for ER11 spanner etc. I just get links to the larger spanner for the actual nut. I'm looking for the other one, to stop the spindle spinning as I try and tighten the nut.
    Any ideas? I've tried a 13mm spanner here but it's too small.. and my 14mm is too loose.


    Many thanks for any help!

  2. #2
    between the two would be a 17/32" or grind a fraction off jaw of an old unwanted 13mm
    Last edited by lucan07; 02-05-2016 at 05:05 PM.

  3. #3
    Quote Originally Posted by lucan07 View Post
    between the two would be a 17/32" or grind a fraction off jaw of an old unwanted 13mm
    Cheers.. I took a smidgen off an old 13mm and all was well again.. much easier with a decent spanner too.. rather than the thin little thing I was sent with it.
    So I managed to get my bank holiday project finished in the end.. cheers!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Chinese 300W DC spindle - is the spindle shaft grounded?
    By HankMcSpank in forum Spindles & Drive Motors
    Replies: 44
    Last Post: 26-11-2016, 07:25 PM
  2. Replies: 5
    Last Post: 29-09-2014, 02:42 PM
  3. Replies: 0
    Last Post: 13-11-2013, 07:50 PM
  4. Spindle lock mechanism for 2.2kW china spindle
    By Jonathan in forum Generic Chinese Spindles
    Replies: 8
    Last Post: 13-08-2012, 08:39 PM
  5. Need to drill a spanner shaft
    By GeorgeD in forum Metalwork Discussion
    Replies: 4
    Last Post: 31-07-2010, 10:38 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •