Hello guys,

I have a small mill and the power supply was so bad to the workshop last timethat I used it that even my grinder kept dimming the lights and the whole lotkept tripping the whole workshop. At that point due to fear of damaging themachine I un-plugged it and left it.
Now I have a new supply to the workshop I am rewiring it.I have heard a lot on here about electrical noise and am concerned, this my situation.My PC for the machine is under the machine mounted to the PC housing is a 4-waysurge protection extension lead which I plug the control box into, the PC and the monitor. Thecontrol box it right next the machine and the monitor, keyboard on top of thecontrol box. What I would like to understand is if I am risk of power supplycables outside control box causing a noise issue. Some of you reading this may wellbe having a good laugh at this point but I do not know the firstthing about electrical noise!
As always any help will be appreciated
Thanks
Steve