Thread: RFQ forum

  1. #1
    Hi all,

    Newbie to the forum here, i run a small cnc shop and i have been looking through the RFQ forum, but i cannot figure out how to get in touch with people.

    It says contact the writer directly?

    Any help will be much appreciated.

    Thanks,

    Jack

  2. #2
    Hi Jack,

    If you click on the name of the person who made the post in question, it should reveal a pop-up with the available contact options for that user.

    .Me
    .Me

  3. The Following User Says Thank You to Lee Roberts For This Useful Post:


  4. #3
    Thanks for the quick reply lee,

    When i click on a name, it comes up with a small box with "view profile" and "view forum posts"??

  5. #4
    Jack,

    Its because your account is going through the approval system, that should now be complete and viewing the pop-up again should give you new options.

    .Me
    .Me

  6. The Following User Says Thank You to Lee Roberts For This Useful Post:


  7. #5
    Lee,

    All sorted,

    Thanks very much.

    Jack

Similar Threads

  1. NEW MEMBER: Hello im Dean and new to the forum, i need CNC help
    By fraserguitars in forum New Member Introductions
    Replies: 2
    Last Post: 14-12-2015, 11:23 AM
  2. NEW MEMBER: New to the forum & cnc
    By elvis in forum New Member Introductions
    Replies: 0
    Last Post: 28-01-2013, 12:52 AM
  3. NEW MEMBER: New to forum.
    By N Holmes in forum New Member Introductions
    Replies: 0
    Last Post: 19-01-2013, 10:02 AM
  4. NEW MEMBER: Hello Forum
    By MickG in forum New Member Introductions
    Replies: 2
    Last Post: 22-08-2010, 10:04 PM
  5. NEW MEMBER: hello forum
    By quicksnail in forum New Member Introductions
    Replies: 1
    Last Post: 22-08-2010, 10:24 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •