1. #1
    hi all, im very stuck and got orders i need to get on with, please help
    everything was working fine last week,
    been to the workshop today to do the xbox controller plug in
    seemed to install every thing ok pluggin and direct x and recognised the controller
    the controler lit up and i programmed the buttons, the reset button worked once but...........
    now the controller nor the key board will move the machine
    machs dro's are going up and down a normal but it is a tho the parallel cable is not connected
    the machine wont do anything, not evan the motors are clicking on reset, one axis makes a very very quiet murmer as tho its getting a voltage but no where near enough to do anythin, but thats it
    i dont have access to the internet at the workshop which is 15 mile from home, so need to get as much info together before i go to try and fix it
    please help :)

  2. #2
    sounds like the definition of ports and pins may have been messed up. Double check that is is all fine there first.
    Machine tools and 3D printing supplies. Expanding constantly.

Similar Threads

  1. USB CNC controller with Arduino UNO and Xbox gamepad support
    By Christian Knuell in forum Machine Control Software
    Replies: 0
    Last Post: 20-10-2015, 08:47 AM
  2. Arc movement issue
    By lukecnc2012 in forum Metalwork Discussion
    Replies: 4
    Last Post: 09-08-2015, 06:15 PM
  3. G53 movement
    By Saracen in forum Programmers Corner
    Replies: 3
    Last Post: 05-02-2015, 06:58 PM
  4. Never simple is it! Mach, machine halts
    By Shinobiwan in forum Artsoft Mach
    Replies: 27
    Last Post: 31-01-2013, 06:11 PM
  5. Machine co-ordinates button in Mach 3
    By alan2525 in forum Artsoft Mach
    Replies: 1
    Last Post: 14-04-2010, 09:57 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts