. .
Page 2 of 2 FirstFirst 12
  1. #11
    safa's Avatar
    Lives in Kumush depe, Iran. Last Activity: 28-07-2020 Has been a member for 1-2 years. Has a total post count of 1.
    Hi, I have a XHC MK3 Ethernet. When i wanna home the machine,The X and Y axis go near the proximity sensor and trigger them, and then instead of reversing the direction it goes straight forward some more and stops (Sensors still in triggered state).
    Does mach3 have config for this ?

    Sent from my SM-N950F using Tapatalk

  2. #12
    Bonjour, ou se branche les swichs des limites ? sur cette carte ?

  3. #13
    Hello everyone, I bought the usb card motion Mk3 I try to put NPN proximity sensor but I’m not sure how to configure in mach3 can you help me?

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 0
    Last Post: 03-01-2015, 03:40 PM
  2. Parallel PCI Card Experience
    By andy0202 in forum Computer Hardware
    Replies: 11
    Last Post: 24-08-2012, 10:39 PM
  3. PCI parallel card / BOB
    By artmin in forum Computer Hardware
    Replies: 11
    Last Post: 30-01-2012, 04:38 PM
  4. plan request connection card PCPPS
    By ali hedi in forum General Electronics
    Replies: 2
    Last Post: 07-04-2010, 08:18 PM
  5. Controller card selection
    By Hogout in forum Motor Drivers & Controllers
    Replies: 7
    Last Post: 14-05-2009, 11:26 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts