Hybrid View
-
26-07-2018 #1
It was an easy enough install but you will need to make mounts for the new spindle to attach to the HEIZ. This is my effort:
It's the 1.5Kw water cooled spindle that I bought with the body dia. of 65mm. I used a standard LPT cable for LPT2 and built a separate control panel.
I bought a long ribbon cable extension for the VFD control panel and I have a manual potentiometer that I can switch to if I want to overide the commands from WinPCNC. Also included is a temperature controller which controls 4 PC fans that are mounted on a van heater matrix and the water flow is supplied by a fish tank pump. That's the LPT2 cable that you can see and then the internal electronics are tapped from that.
-
27-07-2018 #2
I'm looking for something simple. I might connect the water pump to the second AC socket in the Zero3 controller (used for the vacuum, but not enough power for mine) and just had the LPT2 cable and connect to the VFD. The VFD will be close to the zero controller so i can control manually if needed. Should i be concern with the noise created by the VFD near the Zero3?
-
30-07-2018 #3
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Huanyung FVD PD002 not working
By eurikain in forum General ElectronicsReplies: 7Last Post: 28-02-2016, 03:27 PM -
Has anyone had any issues on installing Fusion with Norton on a machine?
By suesi34e in forum Fusion 360Replies: 2Last Post: 27-01-2016, 12:23 AM -
Installing Mach 3 is driving me mad!
By tonygagey in forum Artsoft Mach (3 & 4)Replies: 16Last Post: 13-07-2015, 01:20 PM -
Reversed axis on a AXYZ 6010 after installing DNC controller software...
By RickyThunders in forum Machine Control SoftwareReplies: 1Last Post: 12-02-2013, 03:56 AM -
Installing Mitsubishi inverter FR-E520S-2.2K-EC
By Colin Barron in forum Motor Drivers & ControllersReplies: 5Last Post: 25-09-2010, 07:02 PM
Bookmarks