Page 2 of 2 FirstFirst 12
  1. #11
    Sorry the z axis wiring and board won't drive any of the other motors.but I did check the z motor and it works fine using the x axis wiring

    Sent from my SM-G361F using Tapatalk

  2. #12
    If the Z Motor worked on X axis then the X motor should have worked on the Z axis so either driver, wiring or Config is the problem.
    Last edited by lucan07; 09-05-2016 at 08:56 PM.

  3. #13
    Here are motor output, input signals and output and port setup signals

    Sent from my SM-G361F using Tapatalk

  4. #14
    I just for it to work the wire from the out puts were in the completely wrong place.just need to fix the driver output for the plasma now

    Sent from my SM-G361F using Tapatalk

  5. #15
    So Z axis now working ok?

  6. #16
    Yes he had it fitted to pin 1 and 2 it was ment to be in 6 and 7

    Sent from my SM-G361F using Tapatalk

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Metal Working Lathe
    By DanBlack in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 9
    Last Post: 18-06-2015, 09:47 AM
  2. x&z not working
    By cncjohn in forum Linear & Rotary Motion
    Replies: 5
    Last Post: 18-08-2013, 12:58 PM
  3. EXPERIENCE: Working with JAZZCNC
    By m.marino in forum Trading Experience & Feedback
    Replies: 0
    Last Post: 02-10-2012, 11:47 AM
    By dannymac in forum Items Wanted
    Replies: 0
    Last Post: 25-01-2012, 10:06 PM
  5. Plasma Cutter Drive
    By antsals in forum Plasma Table Machines
    Replies: 0
    Last Post: 23-08-2010, 05:28 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts