Thread: Feeds and speeds software
I am after some feeds and speeds software for the user who knows very littleabout the CNC side of thing. Added to that I only get time every now and thento get on the machine sometime I have no time for months at a time. My mainambition is to do a build but it has been on the back burner.
I am thinking the 3-year subscription of HSM works could be good but I wouldlike to hear from those who know about the software’s.
All the best
I've been searching the same thing, i have tried HSM Advisor and G-Wizard - both are good but I think i will subscribe to HSM as it seems to make more sense to me and also has a neat phone app;)
I've got HSM advisor, as I found it easier to use than G-Wizard at the time I was looking.
However, I bought it a few years ago when they done a lifetime license for 3 computers deal.
The FSWizard website is good enough for covering all the basics, provided you have internet access, so I wouldn't be in any rush to buy a license until you know that you'll make use of it.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
The Following User Says Thank You to m_c For This Useful Post:
Thanks for your msg. It seems I missed out on a good deal. Thank for yourconcern, I am not in a rush to buy either software! On a serious note I have a dilemmathat if I run on average on job a month I would be lucky at the minute, butthat said I am a little out of my depth without the figures!
Thanks now Steve
By Leadhead in forum Computer SoftwareReplies: 9Last Post: 31-10-2015, 08:34 PM
By dudz in forum Tool & Tooling TechnologyReplies: 0Last Post: 26-08-2013, 10:42 AM
By Razorab in forum Sieg Milling MachinesReplies: 13Last Post: 10-02-2013, 08:00 PM
By lateAtNight in forum Machine DiscussionReplies: 5Last Post: 14-11-2012, 11:47 AM
By Web Goblin in forum Tool & Tooling TechnologyReplies: 0Last Post: 20-09-2012, 12:38 PM