. .
  1. #1
    My z drive will work when connected will x axis cable but won't work using its output.the Sri will move on screen the motor is making noise.below is a picture on the diagnostic screen there is a fault but I don't know how to repair it.

    Sent from my SM-G361F using Tapatalk

  2. #2
    When did it last work properly?
    What has changed since then?
    You've done half the diagnosis work, proving that tour Z motor works on an alternate driver, now you need to try your Z driver on another motor to definitively isolate the problem to just your Z driver.
    You don't give any details of your hardware, if I had this fault on my system I would swap out a driver but this is not an option on "All in One" Break Out Board and driver units where one failed driver renders the whole board scrap.

  3. #3
    I Changed the leads from the z to x then the x worked the z fine but the z driver would not work the x .I got the machine with this problem

    Sent from my SM-G361F using Tapatalk

  4. #4
    Examine all the components and tracks on the faulty driver section of the board (both sides) and compare to the good ones, I'm betting there's a toasted component or track somewhere on there.
    Last edited by magicniner; 14-04-2016 at 09:34 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Z drive not working on cnc plasma
    By whensparksfly in forum Machine Discussion
    Replies: 15
    Last Post: 10-05-2016, 02:16 PM
  2. FOR SALE: Assembled Working Portabee
    By calida in forum Items For Sale
    Replies: 0
    Last Post: 19-09-2015, 11:17 AM
  3. x&z not working
    By cncjohn in forum Linear & Rotary Motion
    Replies: 5
    Last Post: 18-08-2013, 12:58 PM
  4. EXPERIENCE: Working with JAZZCNC
    By m.marino in forum Trading Experience & Feedback
    Replies: 0
    Last Post: 02-10-2012, 11:47 AM
  5. BobCAD CAM V24 Working with DXF files
    By aldepoalo in forum BobCAD-CAM
    Replies: 3
    Last Post: 19-03-2012, 08:17 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •