Thread: Change Gear Identification
I acquired some change gears that I thought might be useable on my Hardinge KL1, however they are not.
I'm trying to identify what they were actually off, and wondered if anyone might be able to help identify their use.
I wish to move these on to allow me to get a Myford set that will fit the KL1.
They are 1.5 module gears with a 1" diameter centre hole.
There are the following gears:
44, 45, 50, 52, 58, 60, 63, 70, 80, 90, 94, 95, 96, 115, 117 and 127.
Are they from a lathe, mill maybe?
By petejw in forum Stepper & Servo MotorsReplies: 4Last Post: 13-03-2015, 11:02 PM
By Clive S in forum Stepper & Servo MotorsReplies: 3Last Post: 25-09-2013, 05:35 PM
By Ricardoco in forum General ElectronicsReplies: 5Last Post: 14-05-2013, 08:27 PM
By machineage in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 18-02-2013, 12:36 AM
By clockman in forum Woodworking Project ShowcaseReplies: 9Last Post: 30-01-2011, 10:39 PM