Thread: Z axis moves below set zero
When you decide to stop learning you may as well bin your router, move to the woods, build a rudimentary toilet and become a full time spoon whittler.
- NickIf you will not be swayed by logic or experience simply pick the idea you
like best, but ask yourself why you sought advice in the first place and,
for a simple life, perhaps consider not doing so in future
If you are still there (!) I’ve noticed that -
1) You are running Mach 3 from a PC
2) You always use your phone to post on the forum
Does this mean you do not have easy access to the internet on your PC therefore cannot read the Mach3 manual? It is quite a large pdf document and one which would not be fun to read on your phone.
If this is the case, I’m sure someone could paste out the motor tuning part of the manual as text into a reply post. This would show you exactly what you need to do. I’m away from my home PC so cannot do it right now.
If you took the time to give Info we asked for and gave better replies this would have been fixed ages ago.
Now if you want to try again then go back read some of the posts and give us the info we need.
By pierantoine in forum General ElectronicsReplies: 9Last Post: 23-05-2015, 01:07 PM
By polysoul in forum Machine DiscussionReplies: 9Last Post: 08-06-2012, 11:12 AM
By LoveLearn in forum New Member IntroductionsReplies: 2Last Post: 25-01-2012, 07:46 PM
By deannos in forum General DiscussionReplies: 2Last Post: 28-12-2011, 08:40 PM
By 7AxisCNC in forum Manufacturer NewsReplies: 0Last Post: 17-05-2011, 01:04 PM