. .
Page 2 of 2 FirstFirst 12
  1. #11
    so following on from this threat I decided to do some R&D with different glues and ive found a winner.

    http://www.screwfix.com/p/no-nonsens...ve-200ml/41795

    I also purchased the cheapest 50mm wide masking tap from screwfix and it all worked a treat.

    I used this method but with the glue from screwfix



    just done the below, its pretty small at 100mm by 100mm but the gluing method worked 100% perfect and just popped right off once I was finished. I only used a tiny bit of glue so its going to last ages. it dried and was rock solid in about 30 seconds



    next I want to try cutting letter out like this


  2. #12
    Good Call!
    I use Wickes Mitre Bond, an activated cyanoacrylate, and an aluminium tool plate when I'm machining and/or profiling small parts from gauge plate, stainless and titanium on the milling machine.

    - Nick
    You think that's too expensive? You're not a Model Engineer are you? :D

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Low profile, compact work-holding solutions. Advice sought.
    By Wal in forum Tool & Tooling Technology
    Replies: 23
    Last Post: 26-08-2016, 10:45 PM
  2. Replies: 6
    Last Post: 18-02-2016, 04:19 PM
  3. V fold Tape
    By orangeart in forum General Discussion
    Replies: 2
    Last Post: 11-02-2016, 07:16 AM
  4. Glue for Vacuum Press Veneer?
    By Tenson in forum Woodwork Discussion
    Replies: 16
    Last Post: 05-09-2014, 03:42 PM
  5. Workpiece hold down by glue
    By Robin Hewitt in forum Machine Discussion
    Replies: 2
    Last Post: 30-09-2010, 08:22 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •