hi all. just wired up my em806 drivers and steppers today. two drivers are fine running 3Nm nema 23 motors but my x axis drive which has a 8.5Nm nema 34 has an overcurrent alarm on it (red light blinking once every 3 seconds) I am not sure how to get rid of this. The manual says:
"Over-current protection will be activated when continuous current exceeds the limit or in case of short circuit between motor coils or between motor coil and ground, and RED LED will blink once within each periodic time."
if I disconnect the motor the alarm goes away but reconnect it and the warning is back. I have checked all my connections and none are shorting but not sure what else I have to check, please help