Threaded View
-
13-12-2017 #1
Guys,
Hoping someone can help?
I have just purchased VCarve Destop software and going through the video tutorials.
Every time I create a project either from following the tutorial or my own very simple project the cutter dives down to .5".
I have set up a simple pocket cut of 0.125 and every time the cutter follows along the pattern but 4 times the depth.
I'm using UGCS, xPro Controller V3 and VCarve Desktop. Post processor used in VCarve is G Code (inch)(*.tap)
Would appreciate any ideas or thoughts as I am well and truly stuck.
regards
Tony
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Looking for an CNC xPro controller board
By centurian in forum Spindles & Drive MotorsReplies: 21Last Post: 21-09-2018, 10:03 PM -
VCarve pro problem?
By D-man in forum VectricReplies: 3Last Post: 23-08-2015, 07:49 PM -
vcarve pro 7
By GeoDurie in forum CAD & CAM SoftwareReplies: 3Last Post: 22-05-2014, 02:46 PM -
Motor controller next to break out board?
By m_c in forum General ElectronicsReplies: 2Last Post: 17-11-2010, 01:56 PM -
Controller Board Getting Very Hot / Allegro A3977
By MikeVA in forum Motor Drivers & ControllersReplies: 11Last Post: 08-09-2008, 03:04 AM
Bookmarks