Sieg C3 backlash problem

[John S]

I have fitted these kits in the past and I'm sure they are adjustable.
I think I may still have the bits to one kicking around because I bought a C3 two years ago but seem to have misplaced it somewhere.

Last I saw it was still in a big wooden packing case but can't recall seeing it lately [ note to self - check Tardis No 2 # ]

[irving2008]

I have fitted these kits in the past and I'm sure they are adjustable.
I think I may still have the bits to one kicking around because I bought a C3 two years ago but seem to have misplaced it somewhere.

Last I saw it was still in a big wooden packing case but can't recall seeing it lately [ note to self - check Tardis No 2 # ]

If that was the case John (not saying you're wrong btw), wouldn't the instructions have mentioned it somewhere?

[John S]

Don't recall seeing any instructions, mind you when I find the bits they will have been kicking around for so long that if there were any they would have gone walkabout.

I have fitted these to a few things and can't remember having problems but then again i may have adjusted any play out.

I fitted a set to a Taig mill, they go nearly straight on because these things work on 20tpi screws.
They are just an encoder that counts based on 20.