. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 01-05-2018 #1
    jhonansaro's Avatar
    Lives in dubai, United Arab Emirates.
    jhonansaro
    Last Activity: 05-06-2018 Has been a member for 3-4 years. Has a total post count of 21.
    Hi there
    I am trying to install my 3 phase Spindle using a Delta 7.5 KW Inverter.
    At the moment I can connect to output1 of my BOB(Smooth Stepper) Trough Mach3 by pressing the (Spindle CW F5) Bottom of Mach3, as the result The corresponding Light In front of it (Output1 in my BOB, I am attaching a Picture of it) will light Up. In the picture Output1 corresponds to O1. Also I can connect it to my Inverter, therefore I can Run/stop Spindle from mach3.

    But I just cannot light up the PWM corresponding Light in my BOB from Mach3
    What is it wrong in my mach3 setup? Presently I am dedicating Output1 to Run and/or Stop the spindle, but also, I think I am trying to use the same output1 to connect to my PWM , I really cannot figure it out, any advice is greatly appreciated.

    Regards
    Jhonansaro
    Attached Thumbnails Attached Thumbnails Click image for larger version.  Name: n.png  Views: 164  Size: 597.4 KB  ID: 24150   Click image for larger version.  Name: n2.png  Views: 162  Size: 575.7 KB  ID: 24151   Click image for larger version.  Name: n3.png  Views: 154  Size: 545.9 KB  ID: 24152   Click image for larger version.  Name: n4.png  Views: 159  Size: 560.6 KB  ID: 24153  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. digital to analog servos
    By elad1987 in forum Control Hardware & Systems
    Replies: 3
    Last Post: 15-06-2017, 09:59 PM
  2. Anyone controlling their Huanyang VFD with an analog control voltage?
    By Ger21 in forum Generic Chinese Spindles
    Replies: 9
    Last Post: 16-04-2017, 06:38 PM
  3. Output voltage from mains driver?
    By JW1977 in forum Motor Drivers & Controllers
    Replies: 8
    Last Post: 24-03-2017, 01:33 PM
  4. 5-axis Breakout Includes Hand-Held Control Port & 3,4,5-axis Postion-Display Port
    By LoveLearn in forum General Electronics
    Replies: 12
    Last Post: 25-05-2013, 12:41 AM
  5. parralell port voltage.
    By crossleymarko in forum Computer Hardware
    Replies: 71
    Last Post: 15-04-2012, 09:55 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules