vfd query about the program settings for XSY-AT1 and air cooled spindle

[marbles]

Hi,

I have an XSY-AT1 inverter 3pH, i'm setting it up for the spindle below and just have a bit of a problem with the terminology in my manual, which differs from much of the documentation I see about the HuanYang, which I was using as a reference.

I'm just trying to get the basics set up, 400khz and min freq 120khz etc. What are the following setting I should input for the perameters below?

P00 Max voltage
P01 Reference voltage
P02 Intermediate voltage
P03 Intermediate frequency
P04 Min voltage
P05 Min Frequency
P06 Max operating
P07 Min operating


2.2kw air cooled spindle
current 220v
Current 6a
Frequency 400htz
speed 10-24000htz
2 pole

[Ger21]

I'll never understand why people keep buying these chinese VFD's that noone's ever heard of, and then ask how to set them up???
Did it come with a manual?

[magicniner]

I'll never understand why people keep buying these chinese VFD's that noone's ever heard of, and then ask how to set them up???
Did it come with a manual?

I suspect the reason is that, like many people, They're Cheap! :D

[Ger21]

But they're not any cheaper than a Huanyang, and in many cases, people pay more for them.

[magicniner]

I've stuck with the big 1st world names with brilliant documentation for 20 years, as I put a positive value on my time I figure I'm well ahead of the game ;-)

[marbles]

Apologies for the silence been in the Cairngorms!

I bought it because its dimensional height meant it would fit in my control box. It has a manual (of sorts) Here’s a scanned page with some of the key perameters to set.

If the Huanyang would fit in my control box I would have bought one.