Thinking of getting one of these for a spindle project:

https://www.aliexpress.com/item/130S...355475440.html

Want to interface it into mach3 in speed/torque control mode for on/off & speed 0-10v. Also for e-stop to trigger mach if motor jams/stops if poss.
Anyone used one before?
I can only find Chinese wiring instructions around and wouldn't have a clue which pins to use on the DB25 interface. Or if it can work with mach. Anyone here in the know?
There is already a relay and 0-10v out on my BOB ready to use. And could tie it into my existing e-stop circuit.

Would rather know before I throw money at it.

Daz.