Collet Case - a conversion

[cropwell]

I had these ER20 collets rattling about in a box so I decided to make a case for them.

The donor case was made by my son 25 years ago as a Degree Show (BA 3D Design) exhibit and it contained a 'partickly narsty' bladed knuckle duster (which has been cut up long since). I knocked out the bottom and made a new one to give extra depth and then made a sandwich of closed cell foams to cut an insert.

There are a couple of obvious faults - the sapele insert had a corner knocked off and the catch is not on straight. Also the double sided tape used to hold the foam sandwich to a piece of HIPS got smeared on the foam cut-outs.

But it looks nicer in the workshop than the plastic box the collets were in.