Problems continue and don't know what to do

[Doddy]

As way of explanation - it's not normal (never say never) to lose steps etc in the motor as it decelerates towards zero (before accelerating in the other direction) - which is what is happening at your 3/6/9/12 o'clock positions in the X/Y planes. But what is happening is that any slack / backlash between the screw and the nut (or in the motor coupling or mechanical interface to the spindle), at the point of reversing direction the screw has a limited travel (defined by backlash) before it engages on the contra-face of the thread of the nut to allow it to start accelerating in the opposite direction. Whilst the screw face is moving to interface with the thread of the nut, the spindle isn't moving and that would present a flat-spot at the point of change of direction (3/9 o'clock on X, 6/12 o'clock on Y). That's why we've quickly jumped on to that as a first port of call.

You can also lose steps on change of direction, but this would be limited to one per change of direction and unlikely to be substantially visible just scribing a circle.

[Crazy L]

As way of explanation - it's not normal (never say never) to lose steps etc in the motor as it decelerates towards zero (before accelerating in the other direction) - which is what is happening at your 3/6/9/12 o'clock positions in the X/Y planes. But what is happening is that any slack / backlash between the screw and the nut (or in the motor coupling or mechanical interface to the spindle), at the point of reversing direction the screw has a limited travel (defined by backlash) before it engages on the contra-face of the thread of the nut to allow it to start accelerating in the opposite direction. Whilst the screw face is moving to interface with the thread of the nut, the spindle isn't moving and that would present a flat-spot at the point of change of direction (3/9 o'clock on X, 6/12 o'clock on Y). That's why we've quickly jumped on to that as a first port of call.

You can also lose steps on change of direction, but this would be limited to one per change of direction and unlikely to be substantially visible just scribing a circle.

Thank you very much for that Doddy. Though I do know what backlash is, hahaha, I have worked on some knackered machines in my time as a machinist (leadwell, Huron, Beaver) I'll be honest though, it didn't even cross my mind it could be that. I don't know if my machine has a gib strip, probably not as that is quite an old school thing now. I will have a look this weekend hopefully and let you all know.

[Crazy L]

I have, what feels like about .1 of movement in the Y. I've not taken anything apart, that was just holding the table and giviing it a push and a pull.

I think that could be enough, as on a 10 mil rad, the flat is about 4 to 5 mil wide, sounds feasible that that could be what it is, thanks chaps.

Next mission is to find out how it comes apart, haha.

[dazp1976]

Sounds a lot.
I'd expect a 0.1mm difference at worst if it was backlash. It could be a factor that is certainly not helping though.
How are your bearings? Have they come loose a little?
I'd also try dropping the acceleration rate just to see if it is losing any steps on a direction change.

Bit of checking and maintenence is on the cards.