Threaded View
-
03-04-2020 #1
Hi Chaps,
I can switch the spindle on and off in Mach4 no problem but when I close Mach4 the spindle turns on. I presume this is due to a setting in the smoothstepper. I have stop/start and feed hold state set to "force off". Also I double checked the BOB spindle relay is n/o.
Also how do I configure the spindle to run in 0-10v mode? My BOB does not have a pin no for the 0-10v o/p how do I allocate it in ESS pins config?
Finally does the BOB convert the PWM to anologue volts?
BOB is generic "ECG Savebase"
Cheers
David
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Proximity switches or limit switches
By chillybo in forum Gantry/Router Machines & BuildingReplies: 52Last Post: 29-06-2021, 11:50 AM -
Maplin closing-down sale
By Doddy in forum Classified Ads, Buy, Sell & SwapReplies: 0Last Post: 13-03-2018, 09:13 PM -
Mach4
By D-man in forum Artsoft Mach (3 & 4)Replies: 3Last Post: 18-10-2014, 05:58 PM -
Mach4 in production run G52 offset with Sub
By Lee Roberts in forum Artsoft Mach (3 & 4)Replies: 8Last Post: 25-08-2014, 11:53 PM -
Mach3 vs Mach4
By Saracen in forum Artsoft Mach (3 & 4)Replies: 42Last Post: 15-09-2013, 04:55 PM
Bookmarks