Threaded View
-
24-05-2020 #1
Hello everyone,
Been out the picture for a while due to health reasons however I am now finally designing my CNC conversion for my VM32l.
I have read loads of posts and spoken to various members - and from their excellent advice I have finally narrowed it down.
The mill will be fitted with Ballscrews (2005 on Z / 1605 on X and 1605 / 2005 on the Y undecided still ) and driven directly (no reduction/ gearing )
Power will be the custom Toroidal power supply - as in many of the forums.
The Z already has a internal gas strut.
I have 3x drivers already - (0~7A - 18-80V DM860H) DM860H - however I can sell or save these.
After looking at low inductance I have the following shortlist for all 3x axis:
This stepper with above drivers (0~7A - 18-80V DM860H)
4 Wire- Inductance: 1.85 mH ± 20%(1KHz) - Holding Torque: 4Nm(566.4oz.in)
or a Closed Loop Kit
4 wire - Inductance: 1.8 mH ± 20%(1KHz) - Holding Torque: 3 Nm(424.92 oz.in) with 0~7A(0~5 RMS)+24~50VDC (Typical 36VDC) Driver
or
Closed Loop with separate Driver for the extra vdc
4 wire - Inductance: 1.8 mH ± 20%(1KHz) - Holding Torque: 3 Nm(424.92 oz.in)
0~8.5A(0~6 RMS) - 20~80VAC/30~110VDC (Typical 48/60VDC)
I have tried to keep inductance below 2.0
Any other suggestions are welcome including different motors for different axis and nema 34's etc; however re the torque curves, I see very little benefit and they have a higher MH (3 and upwards)
BONUS QUESTION
How much roughly do people pay re customs and VAT form BST for ballscrews - working on costings
Many Thanks
Mike
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CONVERSION: Weiss VM32 Mill Conversion
By picclock in forum Conversion Build LogsReplies: 18Last Post: 07-08-2019, 11:27 PM -
CONVERSION: Warco WM18 Mill Stepper motor advice
By Gotty101 in forum Conversion Build LogsReplies: 7Last Post: 18-08-2018, 05:06 PM -
Stepper motor selection, lower inductance vs holding torque
By smeg up in forum Stepper & Servo MotorsReplies: 3Last Post: 20-01-2015, 02:43 AM -
Weiss WMD25LV mill
By Bill K in forum Milling Machines, Builds & ConversionsReplies: 4Last Post: 29-06-2014, 12:52 PM -
EXPERIENCE: corkcnc ... a short tale
By purpose in forum Trading Experience & FeedbackReplies: 0Last Post: 29-12-2013, 04:43 PM
Bookmarks