Threaded View
-
18-09-2020 #1
Hi,
Everyone I have a home built 6040 router driven by Gecko G540.All was working well until recently , it was working fine then I stopped the machine to move the workpiece ,when I started up mach3 an hour later she would not run. I have checked all connections and all are good.Strange thing when I use direction arrows on laptop it will not move ,when I dial in a figure in any axis in MDI it moves but very very slowly.If I hit go to zero it does so at normal speed and when I connect my pendant it works fine.Do you think my laptop could be the problem it is a few years old but up to now has been fine.Any ideas or advice would be greatly appreciated.Phil
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
need some help with sinusoidal movement of axis
By donkeyot in forum General DiscussionReplies: 5Last Post: 22-07-2018, 04:54 PM -
Arc movement issue
By lukecnc2012 in forum Metalwork DiscussionReplies: 4Last Post: 09-08-2015, 07:15 PM -
G53 movement
By Saracen in forum Programmers CornerReplies: 3Last Post: 05-02-2015, 07:58 PM -
Forum Slow
By pcstru in forum General DiscussionReplies: 3Last Post: 27-01-2011, 03:54 PM -
stepper speed very slow
By jonm in forum Stepper & Servo MotorsReplies: 17Last Post: 02-11-2009, 12:39 AM
Bookmarks