Threaded View
-
08-02-2021 #1
Guys, I have built a simple Coalescing type system for removing Tramp Oil from CNC machines. The system consists of a floating suction device that is dropped into the machine tank, a centrifugal pump and a Coalescing Plate-Pack type oil water separator that does a good job of removing most tramp oil from the machine coolant tank in less than an hour.
Now, I was wondering what other improvements I can make to this system. How about something to remove odor? An inline filter for metal chips perhaps?
Any other issues you guys face with your machines that you would like to have addressed by such a system?
Any help/leads would be appreciated.
Thanks.
KV
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: You need a CNC to make a CNC.
By quadrilateral in forum New Member IntroductionsReplies: 4Last Post: 25-04-2017, 08:13 PM -
Make your own Super- PID ... not that hard to make ! .... says electronics genius!
By Buba b in forum General ElectronicsReplies: 4Last Post: 26-04-2013, 08:37 AM -
How would you make these, or something near enough...
By irving2008 in forum General DiscussionReplies: 8Last Post: 22-09-2012, 09:36 PM -
Can somebody make me one of these?
By Imtryin in forum General DiscussionReplies: 0Last Post: 28-06-2011, 06:53 PM -
How to make something like this?
By lateAtNight in forum Machine DiscussionReplies: 2Last Post: 13-05-2009, 08:16 AM
Bookmarks