Thread: 1 signal two stepper drives
Threaded View
-
17-02-2022 #1
Iv got a leafboy77 and found out it doesn't support slave function, but my build requires 2 for my Y axis.
Akz250 runs on mach3
Would it be possible to share a single signal to run 2 x stepper drivers? If so would there be any concerns I should be aware of?
I have seen people run 2 steppers off one drive but I think 2 drives running individual steppers will be a better way to go.
Or is there away around this to slave an output?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
eBay: Stepper Motor Controller PWM Pulse Signal Generator Speed Regulator Board £6
By Lee Roberts in forum Items On eBay UKReplies: 7Last Post: 15-07-2018, 08:41 PM -
Stepper motor Pulse Signal Generator module
By Tom J in forum Motor Drivers & ControllersReplies: 8Last Post: 12-01-2016, 11:47 AM -
help sizing toroidal PSU to stepper/drives
By paulus.v in forum General ElectronicsReplies: 13Last Post: 28-01-2014, 06:40 PM -
Stepper Drives
By GTJim in forum Marketplace DiscussionReplies: 4Last Post: 05-04-2013, 12:05 PM -
Nema 34 Stepper Drives,
By drumsticksplinter in forum Gantry/Router Machines & BuildingReplies: 7Last Post: 03-04-2013, 04:20 PM
Bookmarks