Thread: optimum diameter???
Threaded View
-
01-04-2010 #1
On a 500mm axis run what would be the optimum diameter for running it with NEMA 23 motor of between 1.4 to 2.5Nm ratings? currently have a 12mm and looking at the following possibilities:
1) Increasing diameter for more rigidity.
2) Going over to a Ball Screw (Currently running Trapezoidal)
3) Doing both 1 and 2 together for improvement in transfer of force and less flex.
Thanks and good to see the board active. Been away awhile dealing with health and work.
Michael
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Optimum air pressure for the laser air assist?
By Want2build1 in forum Laser Machines & BuildingReplies: 0Last Post: 13-05-2014, 09:50 AM -
Tool diameter accuracy
By Neale in forum Tool & Tooling TechnologyReplies: 15Last Post: 05-03-2014, 11:18 PM -
Optimum voltage for M60STH88-3008DF steppers and 752 drivers?
By Mad Professor in forum Stepper & Servo MotorsReplies: 6Last Post: 26-08-2012, 09:38 PM -
Thread diameter
By Daniel in forum General DiscussionReplies: 7Last Post: 23-02-2012, 06:18 PM -
CONVERSION: Optimum BF20L Conversion
By Rikk in forum Conversion Build LogsReplies: 0Last Post: 17-07-2011, 06:00 PM
Bookmarks