Hi everybody new boy on the site!!

I have just bought a Warco super major mill and done the usual full strip down and re-build and I'm now ready to go CNC:heehee:.
I've been chatting to Marchant Dice about going the whole 9 yards with servo motors, ball screws and the like.
Does anybody have any suggestions or any experience with these mills. Basic machine now re-built is pretty good, rigid and with good slides after lots of time spent scraping and lapping.
Anyway probably going to end up divorced by the time this next bit of the project is finished :twisted:
Looking forward to your comments
Ste64