Thread: Mainul
-
01-10-2010 #1
Hello,
I have entered into the forum with lot of expectation to learn from well experienced members here. Presently I am trying to find out a good USB to Parallel converter. It should have x,y and z controlls with step, direction and enable signals for each stepper motor.
-
01-10-2010 #2
Hi Mainul and welcome to the site. If you are looking for a generic converter to use with a standard stepper controller I don't think there are many that work reliably because of the timing issues. Most of the USB interfaces for CNC use are for use with proprietary software.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks