-
24-10-2010 #1
Hi,
I have a small chinese miller (x travel 400mm, y 150mm, z 85mm) that I converted some years ago to CNC using unipolar Compucut system plus ballscrews. I am currently converting to bipolar using DIYCNC System4, Mach3 plus Kflop usb interface.
I am considering building a gantry router with a bed size of about 1200mm x 600mm.
Searching this forum has proved very useful in solving any problems that I have had.
Cheers
Rob
-
24-10-2010 #2
Hi,
Welcome to the site, your membership has been approved and you now have full access.
Please post your questions in the correct forums for the best assistance.
Lee.Me
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: My introduction
By Ashish in forum New Member IntroductionsReplies: 0Last Post: 29-11-2011, 05:57 AM -
NEW MEMBER: Introduction
By mrpeja in forum New Member IntroductionsReplies: 1Last Post: 23-12-2010, 04:59 PM -
NEW MEMBER: Hello from Newcastle upon Tyne
By eastgate in forum New Member IntroductionsReplies: 1Last Post: 15-12-2010, 10:43 AM -
NEW MEMBER: introduction
By john696d in forum New Member IntroductionsReplies: 1Last Post: 08-12-2010, 01:38 PM -
NEW MEMBER: Introduction
By madd in forum New Member IntroductionsReplies: 1Last Post: 04-12-2010, 01:31 PM
Bookmarks