Thread: Can anyone suggest a motor?
Threaded View
-
20-11-2010 #1
Hi,
I have finished the CNC part of my computerised rose engine (see http://blog.alanbattersby.co.uk/ for picture) but need to drive my cutting frame. For this I require around a 1/2 hp motor that will run continuously for 4+ hours at around 1500-2000+ rpm preferably with speed control. Can anyone suggest a suitable motor/controller combination. Don't know if dc or ac single or 3 phase is best so any advice appreciated.
Thanks Alan
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AC servo motor to replace a 3 phase induction motor on a mill spindle.
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM -
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
Can anyone suggest a Digital dial gague insted of using a probe
By alanb in forum Marketplace DiscussionReplies: 3Last Post: 21-11-2012, 06:48 PM -
servo motor as spindle motor
By Scott in forum General DiscussionReplies: 1Last Post: 03-10-2010, 06:42 PM
Bookmarks