Threaded View
-
10-12-2010 #1
I have a poss customer they dont know how new I am to this and have asked me if this is possible.
I think it is but to be honest I have no idea how to do it.
They would like a small key fob with a 3d relife picture of there kids on it.
I have seen this done on you tube etc but how to get there and do it I think might be beyond me? I have had a good look round for a how to and tutorials but so far have not found anything of use to me.
I have solidworks cad and cam and I think it is poss to use these but again so far no luck with how?
Please tell me if you think this will be beyond me or my ability.
Better to know and say I can not do it rather than look like a fool.Last edited by Kai; 10-12-2010 at 04:12 PM. Reason: carn't spell
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Re my question
By oldwoodworker in forum New Member IntroductionsReplies: 32Last Post: 20-09-2013, 09:07 PM -
diyCAM: Carve Released – Half off ($25) for first 50 customers!
By Chemeleon in forum Manufacturer NewsReplies: 0Last Post: 19-08-2013, 12:46 AM -
Strangest answer to a Simple Question !
By Fivetide in forum General ElectronicsReplies: 4Last Post: 23-09-2012, 12:19 AM -
question ...
By Wobblybootie in forum General DiscussionReplies: 6Last Post: 04-01-2010, 12:04 AM -
A question
By bodgeitandscarper in forum Gantry/Router Machines & BuildingReplies: 7Last Post: 02-12-2009, 08:30 AM
Bookmarks