Thread: wiring help
Threaded View
-
06-06-2011 #1
Hi,
Have finaaly started gathering every thing to start my first build and have the following electronics-
3 X Stepper motors - 3Nm, double shaft (low inductance) (M60STH88-3008DF)
3 X Microstepping Drives - 50VDC, 4.2A (MSD542)
2 X Non-regulated power supplies - 40V, 7A (PS407)
1 X Breakout board
Is the best way to wire this to follow the pdf on this link
http://www.axiscnc.com/pdfdocs/wiring.pdf
Dean
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
VFD to USB WIRING ????
By Stucncusb in forum Spindles & Drive MotorsReplies: 0Last Post: 23-08-2013, 07:06 PM -
cnc wiring
By crossleymarko in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 09-04-2012, 09:35 PM -
help me for wiring
By ali hedi in forum General ElectronicsReplies: 0Last Post: 28-11-2010, 01:20 PM -
Wiring Help
By Toddy in forum Motor Drivers & ControllersReplies: 8Last Post: 23-11-2010, 01:48 PM -
wiring help
By ste68blue in forum Stepper & Servo MotorsReplies: 6Last Post: 29-07-2009, 10:23 AM
Bookmarks