Hi
I have a problem with my TAKASAWA MAC V2E vmc! When I first viewed the machine everything worked fine, but since transport and instalation it has developed a problem thats linked to the air supply / switches I think. Basically I first hooked the vmc up to a small portable compressor ( 25ltr air tank ) I suspected this wouldnt be sufficient but gave it a go. On tool change, the carousel comes out, then as the tool clamp releases it stalls and leaks all pressure? There is no alarm? Today I purchased another air tank to increase the capacity to around 125ltr which should be fine? but the problem still remains? I have tried to manually put in a tool by pressing the tool unclamp button, it makes a noise but doesnt fully open and wont accept the tool pull stud? Near the air inlet and switches there is a small knob that has an air line to it, on the dial it says fast and slow, I have disturbed this and wonder if it has something to do with it? Or is it maybe that the air pressure in the machine system is too low? What pressure should the gauge read on the machine? Any other ideas?
Thanks
Jay