another tool hight setting proble :)

[blackburn mark]

After reading Hilton Steve's post on his tool hight probe and how useful it was i thought id give it a go.
As i am a tad paranoid about driving my tool straight through the probe I also thought I would add a couple of E-Stop switches in parallel under the spring loaded contact


looks posh :)

simple :)

should have grabbed a sharper tool :(

the switches run straight back to my bob E-stop (iv not wired it up yet, ill feel much better when I do)... the washer makes contact to the brass contact through the spring

this could be made much lower profile as its a bit tall... i may have to have another go at this but for now ill see how we get on :)