Thread: servo control vs stepper control
Threaded View
-
13-09-2012 #9
I wouldn't take that route.? The drives are industrial grade and servo's are powerful beast's that unlike steppers tend not to stall when the shit hits the fan.!
For this reason things like limit switch's and E-stops become very important with servo's. They are sensitive to electrical noise and for this reason I wouldn't run any e-stop or limit switch's with 5V, instead using 24V which is more industry standard. So you'll need a 24V PSU so then I'd run the BOB from that, most decent bob's will run off 24V.
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Build Log: Servo Drive and VFD with vector control
By Jonathan in forum Electronic Project BuildingReplies: 17Last Post: 05-04-2015, 07:58 PM -
Speed control
By Saracen in forum Spindles & Drive MotorsReplies: 2Last Post: 29-12-2012, 02:18 PM -
NEW MEMBER: I am going to build a 3 axis servo control
By markey1979 in forum New Member IntroductionsReplies: 8Last Post: 16-11-2011, 12:53 AM -
Help with spindle control
By wizzy in forum Spindles & Drive MotorsReplies: 4Last Post: 12-02-2011, 12:51 AM -
Help! Stepper control board
By Ross77 in forum General ElectronicsReplies: 10Last Post: 28-05-2009, 01:42 AM
Bookmarks