Thread: quick question about lead screw
Threaded View
-
09-02-2013 #1
how critical is it for the nut for the lead screw to be exactly in the middle of the two guide rails? most designs im looking at have the nut right center to the two rails but i have seen some where it sits a little higher or lower.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Quick cable question
By PWD in forum General ElectronicsReplies: 18Last Post: 11-12-2012, 09:25 PM -
FK12 BEARING, tighten on lead screw first - newbie question?.
By Mark Snape in forum Lead Screws, Nuts & SupportsReplies: 4Last Post: 08-03-2012, 10:59 AM -
one lead screw or two
By johngoodrich in forum Gantry/Router Machines & BuildingReplies: 10Last Post: 13-08-2011, 02:39 PM -
Quick question
By m.marino in forum General DiscussionReplies: 2Last Post: 18-02-2011, 04:30 PM -
Lead screw and drive nuts ?
By Kammo1 in forum Gantry/Router Machines & BuildingReplies: 8Last Post: 04-11-2010, 10:46 AM
Bookmarks