how am I going to pull this off?

[kingcreaky]

Ive been asked to manufacture some oak frames.

I need to try and replicate the below 'hand carved' lettering with CNC

Ive used Vcarve, 'Single Line' fonts with a v-bit which is similar, but to achieve the full effect of the attached I think im going to need to think of something a bit more complicated.

any ideas?

for example, the 'O' in love. id need to go deeper on the verticals as shallower on the horizontal ( a bit like caligraphy).

any ideas, pointers etc would be greatly appreciated

Matt