Threaded View
-
29-01-2014 #1
Hi all, I'm nearly ready to test my table now so i thought i'd get the board hooked up to mach3 and get the e-stop, limit and spindle/torch signals working and debugged.
The inputs are fine and perform as needed but i have no output to trigger the relay on the breakout board.
If i reboot the PC, the relay energises and stays on so I'm guessing the LPT port, cable and board/relay are all good.
As soon as i load mach3, the relay drops out and i cannot get it to re-energise again.
The leaflet says its on pin 9 and i have mach3 set for Output1 on pin 9 and spindle fwd/rev to #9
Any ideas as I'm stuck right now and can't progress.
Thanks
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
tree problems!
By kingcreaky in forum Woodwork DiscussionReplies: 8Last Post: 02-06-2014, 12:35 PM -
F-Engrave problems
By cropwell in forum CAD & CAM SoftwareReplies: 29Last Post: 29-06-2013, 03:48 PM -
problems since update
By motoxy in forum General DiscussionReplies: 6Last Post: 02-11-2012, 06:14 PM -
NEW MEMBER: MDF Problems
By MrWiz73 in forum New Member IntroductionsReplies: 4Last Post: 31-12-2011, 12:39 AM -
homing problems in mach3
By johngoodrich in forum Artsoft Mach (3 & 4)Replies: 2Last Post: 17-09-2011, 08:28 PM
Bookmarks