Stepper wiring/colour coding

[rwb97]

Hi guys, I'm new here so apologies in advance for any textbook errors!

I'm looking for some help with some steppers I've just received. The wires coming out of the motor are colour coded as usual, so you can look up on the data sheet which coil they're hooked up to... However on mine, (all three are the same) none of them have the colours in the same order, so if I were to follow the data sheet by colour, then surely they would be wired differently and probably incorrectly!?!

Take a look at what I mean:

Motor number 1:


Number 2:


And number 3:



The motors are Zapp Automation SY60STH86-3008BF (SY60STH88-3008BF) (this link is for a single axle variant, but the datasheet for mine are on the same page. - You may notice I asked my question on their site already, but I don't think it was understood, I probably didn't explain it well enough!

Here's the data sheet:http://www.zappautomation.co.uk/en/a...attachment=140

Lastly, I'm assuming I'm going to have to re-order these wires so that I can follow the data sheet, and there looks like where the wires go into the motor body, the plastic connector bit might be removable... There are what I think are small plastic release clips, but I can't get it to budge and would rather not break it... Any ideas?

Thanks very much in advance to anyone who can help me out here!